Extend The Folding Trailer Arm; Attach The Handlebar - Schwinn Runabout 13-SC250 Owner's Manual

STEP 2

Extend the folding trailer arm

2A
2A. Extend the trailer arm until the two frame ends are flush together. If necessary, move
the quick release bolt and knob out of the way.
2B. Position the square head of the bolt into the squared spot on the frame and screw on
the quick release knob to the other side. Tighten the knob so that the arm can't move.
STEP 3

Attach the handlebar

3A
3A. Unscrew the two Allen-head screws using a 5mm Allen wrench and remove the
handlebar clamp.
3B. Place the handlebar into the groove of the clamp base with the handlebar grips toward
the rear of the trailer bike.
3C. Replace the clamp over the handlebar, insert both Allen head screws back into the
clamp, and tighten with your fingers.
3D. Adjust the handlebar to the desired position and tighten both screws securely with the
Allen wrench. IMPORTANT NOTE: As you tighten the screws, alternate among both to
make sure they are tightened evenly. When properly tightened, the handlebar should
not move.
3B
2B
3C
4
3D