Sound Problems - Epson Ensemble HD User Manual

Sound Problems

Problem
There is no sound.
The high and low parts of the
sound spectrum seem weak.
Bass tones aren't loud enough.
Solution
Check the power switches on the back of the subwoofer. Make sure the
MODE AUTO
switch is in the
MUTE
Press the button on the remote control to make sure the sound wasn't muted
or turned off.
Unplug any headphones that may be plugged into the AV controller.
Try increasing the volume. Depending on your audio source, it's possible that no
sound may be heard at the low end of the +dB range.
If you've connected an external audio device such as an MP3 player, make sure its
volume control is adjusted to allow sound output.
If you've connected an external audio device such as an MP3 player or tape deck,
be sure to select the correct audio port: Select the
control, then select either
AUD2
(for the Audio 2 port in front).
If you've connected an external component, check the Source Assign screen.
Make sure the selected Audio Input matches the port to which the audio is
connected (see page 34).
If you've connected an external video component using an HDMI cable, make sure
HDMI audio is enabled in the component's setup menu. If your component doesn't
support HDMI audio, you may need to connect a coaxial or optical cable to carry
the audio signal (see page 33).
Check for loose or disconnected cables on the back of the subwoofer and
AV controller.
Make sure Midnight Mode isn't turned on. See "Using Midnight Mode" on page 48.
Use the Bass setting to increase the bass. See "Adjusting the Sound" on page 46.
Use the Test Tones function to increase the output of the subwoofer. See "Using Test
Tones to Adjust the Sound" on page 47.
If you rearranged your room or moved your subwoofer to a different location, try
PHASE
switching the control on the back of the subwoofer.
64
MASTER POWER
position and the
AUDIO
AUD1
(for the Audio 1 port in back of the AV controller) or
PWR ON
switch is turned on.
option on the remote