Checking The Projector Lamp; Checking The Info Menu; Checking The Warning Light - Epson Ensemble HD User Manual

Checking the Projector Lamp

The projector lamp lasts for up to 3000 hours. You can use the
(see below). It's time to replace the lamp when:
• The projected image gets darker or starts to deteriorate.
• The message
Replace the lamp
• The projector's warning light flashes red at half-second intervals (see below for details).
Note
Lamp life results will vary depending on mode selected, environmental conditions, and usage. Turn off this product when
not in use to prolong the life of the projector.

Checking the Info Menu

If you have access to the remote control that came with the projector (not the Ensemble HD remote), you can
use it to check the projector's
remote control, you'll need to remove the cover on the bottom of the projector enclosure (see page 56) and
then use the buttons on the projector's control panel to display the
1 Press the button on the projector's remote control or on its control panel.
Menu
2 Use the menu navigation buttons to open the
3 Check the
Lamp Hours
Note
Lamp Hours
The shows 0H until you've used the lamp for at least 10 hours.

Checking the Warning Light

If you suspect that the lamp needs to be replaced, check the warning light on the projector's control panel.
1 Remove the cover on the bottom of the projector enclosure (see page 56).
2
Check the warning light, pictured below.
If the warning light is flashing red at half-second intervals, the lamp needs to be replaced. Contact your
dealer or a qualified servicer, or contact Epson for help (see page 69).
appears on the screen when you start projecting.
menu to find out how long the lamp has been in use. If you don't have the
Info
Info
to determine how long the lamp has been in use.
Warning
light
menu to check how long it's been in use
Info
menu.
Info
menu.
58