Connecting Audio Equipment; Setting Up The Remote Control - Epson Ensemble HD User Manual

Connecting Audio Equipment

You can connect an external audio device, such as a CD player or tape deck, to the Ensemble HD system. Use
an RCA-style stereo cable and connect your equipment's audio output port to the
the AV controller, as shown below:
To record from the AV controller to your tape deck, connect the audio input port on your tape deck to the
port, shown above. If you're not using a tape deck, you can use this port to connect the
2CH OUT
Ensemble HD system to an external amplifier or other home audio system.
Note
2CH OUT
The port is intended for use as a pass-through port. You cannot use the Ensemble HD system to control the
volume of the audio signal transmitted through this port.

Setting Up the Remote Control

After connecting a new component, you can continue to use its original remote control. However, it may be
more convenient to set up the Ensemble HD remote control to work with it. That way, you only need to use
one remote control.
You enable the Ensemble HD remote control to recognize the new component by entering a setup code as
described on page 37. This creates the appropriate commands for your device in one of the remote control
menus listed below:
Component
Cable box
Satellite receiver
High-definition DVD player
Digital video recorder (for example, TiVo)
Video game console
Video cassette recorder
2CH OUT port
36
AUDIO 1
AUDIO 1 IN port
Remote control menu name
CABLE
SAT
HD
DVR
AUX
VIDEO
port on the back of