Removing Or Installing The Microprocessor Fan Duct - Lenovo ThinkServer RD240 Installation And User Manual

On Linux operating systems, you do not need to install any device driver for the
Ethernet card; on Windows operating systems, you need to install the device driver
for the Ethernet card. To install the device driver on Windows operating systems,
do the following:
1. Save any open documents and exit all applications.
2. Insert the ThinkServer EasyStartup DVD that came with your server into the
DVD drive.
Note: You do not need to use the driver disc that came with the Ethernet card.
3. Right-click My Computer and select Properties. The System Properties window
opens.
4. On the Hardware tab, click the Device Manager button. The Device Manager
window opens.
5. Expand the Network adapters and then right-click one of the Ethernet cards
(PRO/1000PT or the yellow question mark).
6. Select Update Driver.... The Hardware Update Wizard program opens.
7. Select Install the software automatically (Recommended) and click Next to
continue.
8. Follow the instructions on the screen.

Removing or installing the microprocessor fan duct

This section provides instructions on how to remove or install the microprocessor
fan duct.
Removing the microprocessor fan duct
Attention
Do not open your server or attempt any repair before reading and understanding the Safety
Information and the Warranty and Support Information on the ThinkServer Documentation DVD
that comes with your product, and "Guidelines" on page 19. To obtain a copy of the
publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove the microprocessor fan duct.
To remove the microprocessor fan duct, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 21.
3. Slide the microprocessor fan duct a little bit backward to release the three
plastic tabs from the chassis. Then, lift the microprocessor fan duct out of the
chassis.
Chapter 5. Installing, removing, or replacing hardware
51