Lenovo ThinkServer RD240 Installation And User Manual page 90

76
Installation and User Guide
Table 17. Submenus under the USB Configuration (continued)
Item
Emulation Type
Table 18. Submenus under the Hardware Health Configuration
Item
Items and options with BMC configuration:
Auto Fan Control
PWM Minimal Duty Cycle
Sensor Data Register
Monitoring
Items and options without BMC configuration:
H/W Health Function
Auto FAN Control
PWM Minimal Duty Cycle
Fan Failure LED Indication
Hardware Health Event
Monitoring
Note: The settings in [ ] are the default settings in the Setup Utility program.
Option
[Auto]
Floppy
Forced FDD
Hard Disk
CDROM
Option
Disabled
[Enabled]
[60% Duty Cycle]
45% Duty Cycle
30% Duty Cycle
Read Only
Disabled
[Enabled]
Disabled
[Enabled]
[60% Duty Cycle]
45% Duty Cycle
30% Duty Cycle
Disabled
[Enabled]
Read Only
Description
Select the type of the USB
device.
Description
If this option is set to
Disabled, the fan runs at the
full speed; if this option is
set to Enabled, the fan speed
is controlled by the system
temperature.
Select the PWM Minimal
Duty Cycle for the fan:
60%-100%, 45%-100%, or
30%-100%.
The sensor data in this
option is for read only. The
detected data includes the
temperature, voltage and fan
speed.
Enable or disable the
hardware monitor function.
If this option is set to
Disabled, the fan runs at the
full speed; if this option is
set to Enabled, the fan speed
is controlled by the system
temperature.
Select the PWM Minimal
Duty Cycle for the fan:
60%-100%, 45%-100%, or
30%-100%.
Enable or disable the fan
alarm function. If this option
is set to Enabled, a message
about fan failure will be
displayed on the POST
screen when the rotational
speed of each fan is less than
800 rpm.
The sensor data in this
option is for read only. The
detected data includes the
temperature and system fan
rotational speed.