The Dhcp Setup Screen - ZyXEL Communications P-660H-T1 v3s User Manual

7.3 The DHCP Setup Screen

Use this screen to configure the DNS server information that the P-660H-T1v3s
sends to the DHCP client devices on the LAN. Click Network > DHCP Setup to
open this screen.
Figure 30 Network > LAN > DHCP Setup
The following table describes the labels in this screen.
Table 19 Network > LAN > DHCP Setup
LABEL
DHCP Setup
DHCP
IP Pool
Starting
Address
Pool Size
Remote DHCP
Server
DNS Server
DNS Servers
Assigned by
DHCP Server
P-660H-T1v3s User's Guide
DESCRIPTION
If set to Server, your P-660H-T1v3s can assign IP addresses, an IP
default gateway and DNS servers to Windows 95, Windows NT and
other systems that support the DHCP client.
If set to None, the DHCP server will be disabled.
If set to Relay, the P-660H-T1v3s acts as a surrogate DHCP server
and relays DHCP requests and responses between the remote server
and the clients. Enter the IP address of the actual, remote DHCP
server in the Remote DHCP Server field in this case.
When DHCP is used, the following items need to be set:
This field specifies the first of the contiguous addresses in the IP
address pool.
This field specifies the size, or count of the IP address pool.
If Relay is selected in the DHCP field above then enter the IP
address of the actual remote DHCP server here.
The P-660H-T1v3s passes a DNS (Domain Name System) server IP
address to the DHCP clients.
Chapter 7 LAN Setup
93