1.3 Hardware Installation
This sections shows you how to install your NWD-271N.
Locate an available USB port on the computer.
1
Remove the protective cap to expose the USB connector. Insert the NWD-271N
2
into an available USB port on the computer.
The NWD-271N's LED (light) turns on if it is properly inserted.
Note: Never bend, twist or force the NWD-271N into the port. If there is not enough
space to attach the NWD-271N, use the included USB cable.
1.4 Software Installation
This section shows you how to install the Mac OS X version of the ZyXEL Utility.
For detailed information on using it, see
1.4.1 Minimum System Requirements
In order to install the ZyXEL Utility for Mac OS X, your computer must meet the
following minimum system requirements:
• 20 MB of free hard drive space
• 128 MB RAM
• Mac OS X 10.3 and higher
NWD-271N User's Guide
Chapter 1 Getting Started
Chapter 4 on page
23.
11