OneWireless™ Series User Manual
6. 5BMaintenance/Repair
6.2. Replacing Antenna
6.2
Replacing Antenna
Tools required
T-15 Security TORX screwdriver (Bit supplied with product) (if applicable)
•
#2 Phillips screwdriver or 1/4 in slotted screwdriver
•
Torque screwdriver
•
Large screwdriver or other flat tool
•
Hex wrench - 1,5mm (supplied with product)
•
Heavy tweezers or needle-nose pliers
•
Procedure
ATTENTION
You must replace your antenna with the same type: elbow or straight.
Stainless steel must be replaced with stainless steel, aluminum with
aluminum. Changing to a different antenna type is not permitted by approval
agencies.
CAUTION
Take precautions against electrostatic discharge to prevent damaging the
sensor module.
WARNING
POTENTIAL ELECTROSTATIC CHARGING HAZARD
The integrally mounted antenna shroud is made of Teflon
resistance greater than 1Gohm per square. When the WCX Series valve
position sensor is installed in potentially hazardous locations care should be
taken not to electrostatically charge the surface of the antenna shroud by
rubbing the surface with a cloth, or cleaning the surface with a solvent. If
electrostatically charged, discharge of the antenna shroud to a person or a
tool could possibly ignite a surrounding hazardous atmosphere.
40
Honeywell Sensing and Control
Issue 3
®
and has a surface
50040849