OneWireless™ Series User Manual
5. 4BOperation
5.1. Overview
5. Operation
5.1
Overview
Display modes
The sensor has the following display modes.
Test. Appears briefly after power-up to self-test the display.
•
Connection status. Appears when sensor is not fully connected to the OneWireless network. See
•
section 5.2.
PV display. Default mode of the sensor displays the PV and any status messages. See section 5.3 on
•
page 24.
Quick view of sensor identification parameters. Displays read-only parameters then returns to PV
•
display. See section 5.4 on page 26.
Menu. See section 5.5 on page 27.
•
Infrared Receiver
To navigate the sensor displays and menus, remove cover and hold the authentication device no more than
152,4 mm [6 in] from the sensor and aim the infrared beam at the sensor display while tapping the device
local configuration buttons (Table 12). You can also use the PDA's buttons.
Figure 8. IR Sensor locations
Authentication device menus are described in section 5.6 starting on page 28.
22
Honeywell Sensing and Control
50040849
Issue 3