Installation Instructions; Freestanding Outdoor Grill Installation - KitchenAid 720-0787 Installation Instructions And Use & Care Manual

Hardware contents pre-installed as noted in instructions
that follow.
REF#
1 1/4*12mm Truss Head Screw
2 1/4*8mm Truss Head Screw
3 5/32*10mm Countersunk Head
4 5/32*10mm Truss Head Screw
5 1/4*10mm Support Bracket Screw
1 2
Preparation
Before beginning assembly, make sure all parts are present.
Compare parts with package contents list and diagram above.
If any part is missing or damaged, do not attempt to assemble
the product. Contact customer service for replacements parts.
•
Estimated Assembly Time: 20 minutes
•
Note: The right and left sides of the grill are designated as if
you are facing the front of the grill.

INSTALLATION INSTRUCTIONS

Freestanding Outdoor Grill Installation

Description
screw
3 4
Swivel Caster Assembly
1. Unpack bottom panel and 4 casters. Remove 16 screws
pre-assembled on the bottom panel and use those screws to
secure the four casters. Two casters (H) should assemble on
the line of left side, swivel caster (I) assemble on the front right
side, swivel caster with brake (J) assemble on the rear right
side as shown below.
H
QTY
34pcs
4pcs
4pcs
6pcs
8pcs
Cart Assembly Cart Assembly
1. Unpack the left side panel (B) , right side panel (C) and rear
panel (D). Loosen 8 screws which are pre-assembled on the
bottom panel and 6 pre-assembled screws on the left and
right side panels.
5
2. Secure the left side panel (B) by clipping the open hole
onto the screws which is pre-assembled to the bottom
panel and tighten the 3 screws.
s
I
J
B
11