KitchenAid 720-0787 Installation Instructions And Use & Care Manual page 13

7. Attach door to cart by aligning the screw holes on the door
(E) with the screw holes in the door hinge (L). Insert the screws
into the door hinge then into the door and tighten as shown
below.
Note: Door may misalign when grill is rolled over uneven ground or
positioned on uneven ground. To adjust door alignment the hinges
need to be adjusted. Loosen the screws marked A securing the
door hinges. Hold door and hinges in desired position and tighten
screws to secure the hinges. To adjust door angle, turn screws
marked B clockwise to move door left and counterclockwise to
move door right.
A
8. Loosen 2 screws which are pre-assembled on the cart frame
(K) and 2 screws pre-assembled on the heat shield (F), hang the
heat shield between the cart frame and rear panel of cart by the
screws previously loosened, and tighten screws.
K
Note: Make sure Gap on the heat shield (F) should be located on
the front right corner. Shown as above figure.
L
E
B
F
Firebox Assembly
1. Remove the 4 screws under the firebox (A) on each corner.
Place the firebox on the cart as shown with the hose inside the
cart and reattach the 4 screws. Tighten to secure.
Note: Make sure the LP regulator hose is placed through the
gap area of the heat shield and is inside the cart when
attaching firebox assembly.
Side Shelf Assembly
1. Remove the 4 pre-assembled top screws on each corner
bracket.
Gap
Remove the top screw and nut
A
B
A. Top screw
B. Bottom screw
A
13