Safety Information; Electric Shock Hazard; Installation And Operation; Maintenance And Repair - Bosch VIP-X1XF Installation And Operating Manual

8 en | Safety information
2

Safety information

2.1

Electric shock hazard

–
–
–
–
–
–
–
2.2

Installation and operation

–
–
–
–
2.3

Maintenance and repair

–
–
–
DOC | V4.54 | 2011.09
Never attempt to connect the unit to any power network other than the type for which it
is intended.
Use only power supply units with UL approval and a power output according to LPS or
NEC Class 2.
Never open the housing.
Never open the housing of the power supply unit.
If a fault occurs, disconnect the power supply unit from the power supply and from all
other units.
Install the power supply and the unit only in a dry, weather-protected location.
If safe operation of the unit cannot be ensured, remove it from service and secure it to
prevent unauthorized operation. In such cases, have the unit checked by Bosch Security
Systems.
Safe operation is no longer possible in the following cases:
– if there is visible damage to the unit or power cables,
– if the unit no longer operates correctly,
– if the unit has been exposed to rain or moisture,
– if foreign bodies have penetrated the unit,
– after long storage under adverse conditions, or
– after exposure to extreme stress in transit.
The relevant electrical engineering regulations and guidelines must be complied with at
all times during installation.
Relevant knowledge of network technology is required to install the unit.
Before installing or operating the unit, make sure you have read and understood the
documentation for the other equipment connected to it, such as cameras. The
documentation contains important safety instructions and information about permitted
uses.
Perform only the installation and operation steps described in this manual. Any other
actions may lead to personal injury, damage to property or damage to the equipment.
Never open the housing of the VIP X1 XF. The unit does not contain any user-serviceable
parts.
Never open the housing of the power supply unit. The power supply unit does not contain
any user-serviceable parts.
Ensure that all maintenance or repair work is carried out only by qualified personnel
(electrical engineers or network technology specialists).
Installation and Operating Manual
VIP X1 XF
Bosch Sicherheitssysteme GmbH