Switching On The Device For The First Time - Fujitsu M2010 Operating Manual

First-time setup of your device
Switching on the device for the first time
Switchingon for thefirsttime
The device must be supplied with power through the mains adapter during this process.
When you switch on the device for the first time, the supplied software is
installed and configured. Because this procedure must not be interrupted,
you should set aside enough time for it to be fully completed and connect
the device to the mains using the mains adapter.
During the installation process, DO NOT restart the device unless
you are requested to do so!
You can find information on how to restore the operating system, drivers, manuals
and special software in the "Recovery Process" manual.
To make it easier to use your device for the first time, the operating system
is pre-installed on the hard disk.
► During installation, follow the instructions on screen.
Consult the operating system manual if anything is unclear about the requested input data.
If a Windows operating system is installed on your device, you will find more
information on the system and drivers, help programmes, updates, manuals etc.
on the device or on the Internet under "http://ts.fujitsu.com/support".
10
► Switch on your device.
A26391-K245-Z220-1-7619, edition 1