Connecting An External Monitor; Setting The Refresh Rate For Your External Monitor - Fujitsu M2010 Operating Manual

Connecting external devices

Connecting an external monitor

You can connect an external monitor to the analogue VGA monitor connection of the
notebook. Screen output is limited to a maximum of two screens at any one time (see
"Key combinations", Page
Monitorport Screenport VGAconnection socket Monitor
Analogue VGA monitor connection socket
► Switch off the notebook and the external monitor.
► Connect the data cable of the external monitor to the monitor port of the notebook.
► First switch on the external monitor and then the notebook.
Using the
the external monitor and the notebook's LCD screen.
You can display the same picture on the external monitor and the
notebook LCD screen simultaneously.

Setting the refresh rate for your external monitor

Monitor
If the refresh rate set is too high, the monitor may be damaged. Please see the
documentation included with your monitor for the maximum possible refresh rate.
By setting the optimum refresh rate you will avoid screen flicker.
► Set the appropriate refresh rate for the type of monitor connected.
► Select Startsymbol – (Settings) – Control Panel – Appearance and Personalization
– Personalization: Adjust screen resolution.
or
► Right-click on the desktop. Under Personalization – Display Settings, choose screen type 1 or 2.
► Select Advanced Settings – Monitor.
► Select Screen Refresh Rate to choose the optimum refresh rate for the connected monitor type.
► Click Apply and OK.
34
16, section "Toggle output screen").
+ key combination, you can toggle back and forth between
Fn F10
A26391-K245-Z220-1-7619, edition 1