Table of Contents
Advertisement
Step 4. To hang the fan body in the canopy, hold
the fan body firmly and insert the ball into the
canopy opening. Check that no wires were pinched.
Rotate the fan body until the slot in the ball fits
into the pin opposite the canopy opening.
Note: Independent control of the light fixture
using a W-80 or W-81 requires an additional
independent power wire run from the wall switch
to the fan. See Page 7 for wiring.
CANOPY ELECTRICAL CONNECTIONS
Step 5. Attach the fan wires to the ceiling fixture outlet box
wiring by twisting the bare ends of the wires together and then
securing with a wire nut. Test that the connection is secure by
pulling on the wire nut. Connect in this order:
Step 6a. W-80or W-81 Wiring Connections - NO light
fixture
• GREEN leads from mounting plate and fan to GROUND
conductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to RED wire from W-80 in
ceiling outlet box. Secure with wire nut.
• Cap BLUE D-1 Option wire with wire nut.
Step 6b. W-80 or W-81 Wiring Connections - WITH light
fixture
• GREEN leads from mounting plate and fan to GROUND
conductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to RED wire from W-80 in
ceiling outlet box. Secure with wire nut.
• BLUE wire from fan to YELLOW wire from W-80 in ceiling
outlet box. Secure with wire nut.
NOTE: See page 7 for additional wiring information.
Step 7. Tuck the wires into the canopy with the
wire nuts pointed upwards, so that the WHITE
and BLACK wires are on opposite sides of the
canopy and all wires are clear of the canopy
opening.
Step8. Install canopy hatch with the last canopy
screw and lock washer. To insert canopy screw, tilt
the fan body away from the hatch opening.
Step 9. Straighten the fan, then check to ensure
that there is no movement between the canopy and
ceiling or Hang-Tru ball and 12" extension tube.
6
HANGING THE FAN
Capped
Blue
D-1 Option
Wire on
3-Speed Only
for Independent
W-81 Light
Control
CANOPY HATCH INSTALLATION
Canopy
Ball
Slot
DO NOT attempt to attach the blades until after the fan body is
attached to the ceiling and Steps 5, 6, 7 and 8 are completed.
Capped
D1-Option Wire
Black & Red
Wires
2 White Wires
3 Green Wires
Wire Nut
Blue & Yellow
Wires
Black & Red
Wires
2 White Wires
3 Green Wires
Hatch
Canopy
Washer
Canopy
Screw
Pin
W-81 Connections
No Light Fixture
W-81 Connections
With Light Fixture
Tilt the
Fan to
Install
Last
Canopy
Screw
Advertisement
Table of Contents
