Casablanca S3 Owner's Manual page 4

CROSSBAR mOUNT-
INg BRACKET
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
crossbar mountInG bracket InstallatIon
proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the
bracket, with ground wire and ridges down, to the ceiling
fixture outlet box with the mounting hardware included with
the outlet box.
Tighten the screws firmly by hand only, being careful not to
bend the bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
canopy
HATCH
4
ceIlInG hardware
Wire nut (4)
GETTING STARTED
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked 'Approved for ceiling fan mounting' . If it is
not, a new box must be installed.
CEILINg
wIRINg
CROSSBAR
mOUNTINg
BRACKET
canopY hardware
canopy
addiTional hardware
2
screWs (2)
1" x 8-32 ROUND
head screWs (2)
noTe: The fan weight is 23 pounds.
FLAT
wASHER
canopy screW (4)
canopy Lock Washer (4)
" x 8-32 ROUND HEAD
1
/
4
FLat Washer (2)
CEILINg FAN
approved
wIRINg BOX
RIDgE
SIDE
DOwN
gREEN
gROUND
wIRE
approved
OUTLET BOX
HARDwARE