Casablanca S3 Owner's Manual page 7

step 9. Screw the 100 Watt Halogen bulb into the socket.
Do not touch the glass bulb with your fingers–it is extremely
important that the glass be clean. If it is touched, or dirty,
clean carefully with a tissue. A dirty glass bulb will cause the
bulb to fail almost immediately.
imporTanT! When installing the halogen bulb, care-
fully cut off the end of the plastic sleeve the bulb
comes in and hold the bulb by the plastic sleeve to
screw it into the socket.
Step 10. Position the indentations in the outer rim of the
glass shade so that they line up with the tabs on the inside
surface of the fan light fixture rim.
Step 11. Carefully lift the glass shade up inside the light
fixture as far as it will go.
Step 12. Rotate the shade in a clockwise direction until it is
held tightly in place by the three tabs.
note: In compliance with US Federal Energy Regula-
tions, this ceiling fan contains a device that restricts
the light kit to a maximum of 190 watts. Exceeding
that limit or the marked limit on this product may
result in fire hazard or improper operation.
savInG moneY wIth Your ceIlInG Fan
i n s u m m e r , the movement of
air creates a cooling "wind chill"
effect. A room can actually feel
several degrees cooler, without set-
ting the thermostat lower.
INSTALL BULB AND GLASS
HALOgEN BULB
100 wATT
i n w i n T e r , hot air rises to the
ceiling while cool air settles to the
floor. Trapped against the ceiling,
the warm air is wasted. If you turn
up the thermostat, energy costs
will rise.
S3
gLASS
SHADE
r u n n i n g i n r e v e r s e , your
Casablanca fan can recirculate
warm air near the ceiling down
into the living area, providing even
heating and comfort (with a pleas-
ant effect on heating bills).
™
TABS
gLASS SHADE
INDENTATION
7