Cisco 880 Series Hardware Installation Manual page 66

Hardware Features
Table 1-10 LED Descriptions for the Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series ISRs (continued)
LED Color
14
SFP EN Off
Green
Amber
SFP S Green
1. SSID = service set identifier.
2. LWAPP = Lightweight Access Point Protocol.
3. PPP = Point-to-Point Protocol.
4. xDSL = General term referring to various forms of DSL, including ADSL (asymmetric digital subscriber line) and VDSL (very-high-data-rate digital
subscriber line).
5. DSLAM = digital subscriber line access multiplexer.
6. ATM = Asynchronous Transfer Mode.
7. EFM = Ethernet in the First Mile.
8. 3G = Third-Generation.
9. WWAN = wireless WAN.
10. RSSI = Received Signal Strength Indicator.
11. GSM = Global System for Mobile Communication.
12. CDMA = code division multiple access.
13. SRST = Survivable Remote Site Telephony.
14. SFP = small-form-factor pluggable.
Table 1-11
867VAE-K9 ISRs.
Table 1-11 LED Descriptions for the Cisco 866VAE, Cisco 867VAE, Cisco 866VAE-K9, and Cisco 867VAE-K9 ISRs
LED Activity
Power/System Power/System LED: Solid
GE_MODE LED: Off
DSL_LINK LED: Off
Power/System LED: Solid
GE_MODE LED: Solid
DSL_LINK LED: Off
Power/System LED: Solid
GE_MODE LED: Off
DSL_LINK LED: Solid or
flashing
1
xDSL ACT Green
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
1-50
Description
Not present.
Present and enabled.
Present with failure.
Blinking—Blinking frequency indicates port speed.
describes the LEDs for the Cisco 866VAE, Cisco 867VAE, Cisco 866VAE-K9, and Cisco
Description
Power is on and system running in the Rommon mode.
During the early booting stage, both Power/System, GE_MODE and
Note
DSL_LINK LED will be turned on temporarily for the power on test.
DSL_LINK and GE_MODE LED will be turned off later after booting
into Rommon.
IOS functioning in GE WAN mode.
IOS functioning in DSL_WAN mode.
In IOS DSL_WAN mode, DSL_LINK LED will be solid after DSL
Note
training complete or flashing during training.
On—DSL interface is up.
Blinking—DSL WAN activity (traffic in either direction).
Faster blinking—Heavier traffic
Off—Device is powered off or the DSL WAN interface is down.
Chapter 1 Product Overview
860 Series 880 Series 890 Series
— — 892F
models
— —
— —
— — 892F
models
OL-16215-12