Bang & Olufsen BeoVision 8 Reference Book page 25

Connect a video recorder
BeoVision
AV1
Video recorder
Disconnect all involved systems from the mains
before you connect external equipment.
> Connect one end of a 21-pin AV cable to the AV
socket on the rear of the recorder.
> Then run the cable to on of the AV sockets on
the back of the television.
Aerial connection
Use your external aerial connection (or cable TV
network connection) and the aerial cable supplied
with the video recorder.
> Connect the cable from your external aerial to
the signal input socket marked
panel of the recorder.
> Direct the aerial signal to the television, using
the aerial cable supplied with the recorder.
> Plug one end into the socket marked TV on the
recorder and the other end into the aerial socket
marked AERIAL on the television's socket panel.
TV
TV
Video recorder
If you connect a video recorder to your television,
and a decoder is connected to your television, you
can only record decoded channels via instant
recording. Press RECORD, RECORD on Beo4 to
start a recording of a decoded channel. Please
note that you must not change to another
decoded channel during recording. If you change
to another channel, the recorder will start
recording this newly selected channel.
on the rear
AERIAL
25