Bang & Olufsen BeoVision 8 Reference Book page 24

24
Connect a set-top box
Disconnect all involved systems from the mains
before you connect external equipment.
> Connect one end of a 21-pin AV cable to the
set-top box.
> Run the cable to one of the AV sockets on the
back of the television.
> Connect the IR transmitter to the C1 or C2
socket on the television.
> If your set-top box delivers HDMI video signal,
connect the set-top box to the HDMI socket also.
> Fasten the IR transmitter to the IR receiver of
the set-top box.
To be able to use the remote control included with
your set-top box, do not cover its IR receiver entirely.
>> Connect additional video equipment
BeoVision
AV2
Automatic standby ...
When you register a set-top box in the
CONNECTIONS menu, you can also select
an 'AUTO STANDBY' time for your set-top box.
This means that you can select if the connected
set-top box should switch to standby automatically.
The options are:
AFTER 0 MIN ... The set-top box switches to stand-
by immediately when you select another source.
AFTER 30 MIN ... The set-top box switches to
standby 30 minutes after you have selected
another source*.
AT TV STANDBY ... The set-top box switches to
standby when you switch the television to standby.
NEVER ... The set-top box does not switch to standby
automatically.
FOLLOW TV ... The set-top box switches on,
when you switch your television on and it
switches to standby, when you switch your
television to standby.
C1 / C2
Set-top boxes must be set up in accordance with
the documentation enclosed with them.
*If you switch the television to standby before the
30 minutes have passed, the set-top box is also
switched to standby.
Set-top box