Bang & Olufsen BeoVision 8 Reference Book page 23

Connect a decoder
BeoVision
AV1
Disconnect all involved systems from the
mains before you connect external equipment.
> Connect the cable from the external aerial to
the socket marked AERIAL on the television.
> Connect the decoder to one of the 21-pin AV
sockets on the television's socket panel.
If you wish to connect an RF decoder, connect the
external aerial cable to the decoder input socket
and then forward the signal or cable to the
television's aerial socket (marked AERIAL).
Decoder
Tuned channels and decoder detection
In most cases, a connected decoder is registered
automatically during tuning. The decoder should
automatically detect those channels which require
decoding. However, if this is not the case, then
adjust the setting via the MANUAL TUNING menu
for the channel in question. Please refer to the
section entitled 'Adjust tuned TV channels' in the
chapter 'Edit tuned channels' on page 10.
23