Onchip Ide Device - Foxconn BLACKOPS User Manual

OnChip IDE Device

SATA Mode
LEGACY Mode Support
x Turbo Memory Support
OnBoard IDE/SATA Chip
↑↓��������:Move Enter:Select ��������:Move Enter:Select
F5:Previous Values
► SATA Mode
This item is used to set the Serial ATA Mode. Setting options: �IDE��; �RAID��; �AHCI��.
The SATA interface is controlled by Intel ® south bridge chip ICH9R.
► LEGACY Mode Support
There are Native IDE and Legacy (or compatible) IDE modes. Legacy mode supports OS
through legacy IDE driver. Most SATA functions are not supported in Legacy mode, like SATA
II 3G, NCQ, Hot Plug and etc, and Native mode supports SATA II 3G, NCQ, and Hot plug.
This item is used to enable/disable the Legacy IDE mode support for the SATA ports. Certain
OS is not supported under Native mode, and must choose Legacy mode.
► Turbo Memory (Robson Technology) Support
Turbo Memory (Robson Technology) features an integrated disk cache using flash memory
in order to speed up disk access and also save energy. It uses non-volatile memory (Flash
memory) to increase system responsiveness, make multi-tasking faster, and extend battery
life.
This item is used for supporting the Turbo Memory.
► OnBoard IDE/SATA Chip
You may set your PATA and e-SATA to IDE mode or RAID Mode or AHCI+IDE mode(AHCI for
e-SATA, IDE for PATA). We are using JMicron chip to control PATA and e-SATA devices.
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Device
:Move Enter:Select +/-/PU/PD:Value F10:Save +/-/PU/PD:Value F10:Save +/-/PU/PD:Value F10:Save
F6:Fail-Safe Defaults
IDE IDE
Disabled
Disabled Menu Level ►
IDE Mode
ESC:Exit F1:General Help ESC:Exit F1:General Help ESC:Exit F1:General Help
F7:Optimized Defaults
35
Item Help