Onboard Floppy Controller - Foxconn A7VA Series User Manual

support for EHCI BIOS handoff will be available in Windows XP SP2.
This item allows you to enable support for OS without EHCI hand-off feature.
This is a workaround for OS without EHCI hand-Off support .
The EHCI ownership change should claim by EHCI driver.
If USB devices are connected to the computer, the following item will appear :
► USB Storage Configuration
After pressing <Enter>, you can set the reset delay for the USB mass storage device. There
are many different emulation types of this USB device, such as floppy, hard disk and CDROM
can be selected.
SuperIO Configuration
SuperIO Configuration SuperIO Configuration

OnBoard Floppy Controller

Serial Port1 Address
IR Address IR Address
IR Mode
IR Duplex Mode
↑↓←→:Move
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► IR Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IR port.
► IR Mode
This item is used to set the IR mode. The available settings are :[IrDA] : An IrDA device for
maximum 115200 bit/s.[AS� IR] : A faster IrDA for 1152000 bit/s.
► IR Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
emulation types of this USB device, such as floppy, hard disk and CDROM
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
SuperIO Configuration
Enter:Select
F1:General Help
Help Item
[Enabled] [Enabled] Allows BIOS to Enable
[3F8/IRQ4] or disable floppy
[2F8/IRQ3] controller.
[IrDA]
[Half Duplex]
+/-/:Value F10:Save
F9:Optimized Defaults
37
There
ESC:Exit