SuperIO Configuration
SuperIO Configuration
OnBoard Floppy Controller
Serial Port1 Address
IR Address
IR Mode
IR Duplex Mode
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► IR Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IR port.
► IR Mode
This item is used to set the IR mode. The available settings are :
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► IR Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
SuperIO Configuration
↑↓←→:Move Enter:Select
F1:General Help
Help Item
[Enabled]
[Enabled]
Allows BIOS to enable
[3F8/IRQ4]
or disable floppy
[2F8/IRQ3]
controller.
[IrDA]
[Half Duplex]
+/-/:Value
F10:Save
F9:Optimized Defaults
38
ESC:Exit