Fox Intelligent Stepping - Foxconn A7VA Series User Manual

Fox Intelligent Stepping

CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
CPU Clock Adjust
PCIE Clock Adjust
CPU Multiplier Adjust
Memory Speed Mode Memory Speed Mode
GFX Engine Clock Override
GFX Engine Clock
Spread Spectrum
↑↓←→:Move
► CPU Clock Adjust
This option is used to adjust the CPU clock.
► PCIE Clock Adjust
This option is used to adjust the speed of PCI Express slot. It may enhance the graphics card
speed.
► CPU Multiplier Adjust
This option is used to adjust the CPU Clock Ratio. Multiply CPU clock with this ratio, you can
get the CPU speed. Increase this ratio may overclock your CPU. This option will be valid if
your CPU ratio is unlocked and will be displayed only if your CPU is supporting this feature.
► Memory Speed Mode
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memory
module. It contains important information about the module's speed, si��e, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory device.
Select [Auto] for SPD enable mode.
Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory
Speed Adjust" item. If SPD value is faster than "Memory Speed Adjust" value, it will run at the
specified "Memory Speed Adjust" speed. Otherwise, SPD value is selected.
Select [Manual], then DRAM speed is manually selected according to the set value of
"Memory Speed Adjust".
► Memory Speed Adjust
This item will appear only when the "Memory Speed Mode" is set to [Limit] or [Manual].
The available settings are : [400MH��], [533MH��], [667MH��], [800MH��], [1066MH��].
[1066MHz] will appear only in AM2+ CPU.
► GFX Engine Clock Override
This item allows you to enable/disable GFX Engine Clock Override support.
► GFX Engine Clock
This item will appear only when "GFX Engine Clock Override" is set to [Enabled], it allows you
Fox Intelligent Stepping
[200]
200
[100]
[Auto]
[Auto] [Auto]
[Enabled]
[350]
[Enabled]
Enter:Select
F1:General Help
+/-/:Value F10:Save
F9:Optimized Defaults
27
Help Item
ESC:Exit