Superio Configuration; Onboard Floppy Controller - Foxconn G43MX Series User Manual

SuperIO Configuration

CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
SuperIO Configuration

OnBoard Floppy Controller

Serial Port1
IrDA Function
IrDA Duplex Mode
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
OnBoard CIR Port
CIR Port IRQ
↑↓←→:Move Enter:Select
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1
This item is used to enable/disable the onboard serial port1.
► IrDA Function
This item is used to enable/disable onboard infrared chip function.
► IrDA Duplex Mode
This item enables you to determine the transfer mode of the onboard infrared chip.Setting
values are: [Full Duplex] and [Half Duplex].
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel port.
► Parallel Port Mode
This item is used to set parallel port mode.
► Parallel Port IRQ
This item is used to assign the interrupt request (IRQ) for the onboard parallel port.
► OnBoard CIR Port
This item specifies the base I/O port address of the onboard Consumer IR port.
► CIR Port IRQ
When "OnBoard CIR Port" is set to [2E0]、[3E0]、[298], this item is used to allow BIOS to
select Consumer IR port IRQ.
SuperIO Configuration
[Enabled]
[Enabled] or disable floppy
[Enabled] controller.
[Half Duplex]
[378]
[Normal]
[IRQ7]
[2E0]
[IRQ10]
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
36
Help Item
Allows BIOS to enable
F1:General Help