Dram Timing Configuration - Foxconn A76GMV User Manual

DRAM Timing Configuration

CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
DRAM Timing Configuration
Memory Speed Mode
DRAM Timing Mode
► Memory Speed Mode
This item is used tu enable/disable provision of DRAM timing by SPD device.The Serial Pres
ence Detect (SPD) devise is a small EEPROM chip,mounted on a DDR3 memory module.It
contains inportant information about the module's speed,size,addressing mode and various
other parameters,so that the motherboard memory controller (chipset) can better access the
memory device.
Select [AUTO] for SPD enable mode.
Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory"
Select [Manual],then DRAM speed is manually selected according to the set value of "Memory
Speed Adjust".
► DRAM Timing Mode
When both DCTs (DRAM controller) are enabled in unganged mode, BIOS must initialize
the frequency of each DCT in order, you also can configure the timings manually.
Settings are : [Auto], [DCT 0], [DCT 1], [Both].
DRAM Timing Configuration
[Auto]
[Auto]
↑↓←→:Move Enter:Select
F1:General Help
Help Item
Auto
Limit
Manual
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
34
Options