Fox Intelligent Stepping - Foxconn A76GMV User Manual

Fox Intelligent Stepping

CPU Clock Adjust
CPU Multiplier Adjust
Current CPU Speed
CPU-NB HT Link Speed
Current FSB/HTT Speed
CPU-NB Multiplier Control
Current CPU-NB Speed
Memory Speed Mode
Current DRAM Speed
GFX Engine Clock Override
PCIE Clock Abjust
Spread Spectrum
► CPU Clock Adjust
This option is used to adjust the CPU clock.
► CPU Multiplier Adjust
This option is used to adjust the CPU Clock Ratio. Multiply CPU clock with this ratio, you can
get the CPU speed. Increase this ratio may overclock your CPU. This option will be valid if
your CPU ratio is unlocked and will be displayed only if your CPU is supporting this feature.
► CPU-NB HT Link Speed
HT stands for HyperTransport bus. The CPU<->NB HT Speed option controls the physical
speed of the CPU to Northbridge HT link. The physical speed of the link is determined by
multiplying the CPU clock with the CPU<->NB HT Speed setting.
► CPU-NB Multiplier Control
This item is used to select CPU-NB Multiplier run as Auto or Manual mode.
Select [Auto] for CPU-NB default speed.
Select [Manual], then CPU-NB speed is manually selected according to the setting of "CPU-
NB Multiplier Adjust".
► Memory Speed Mode
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a memory
module. It contains important information about the module's speed, size, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory device.
Select [Auto] for SPD enable mode.
Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory
Speed Adjust" item. If SPD value is faster than "Memory Speed Adjust" value, it will run at the
specified "Memory Speed Adjust" speed. Otherwise, SPD value is selected.
Select [Manual], then DRAM speed is manually selected according to the set value of "Memory
Speed Adjust".
► GFX Engine Clock Override
This item allows you to enable/disable GFX Engine Clock Override support.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Fox Intelligent Stepping
: 3000MHz
: 2000MHz
: 2000MHz
: N/A , 800MHz
↑↓←→:Move Enter:Select
F1:General Help
[200]
200
[Auto]
[Auto]
[Auto]
[Auto]
[Disabled]
[100]
[Enabled]
+/-/:Value F10:Save
F9:Optimized Defaults
29
Help Item
ESC:Exit