Bosch Flasher-PRO User Manual page 12

and correct problems. Please visit the Bosch download page at:
http://www.boschdiagnostics.com
To update the Flasher-PRO firmware: Apply power to Flasher-PRO.
Load the configuration webpage in a web browser, and follow the
instructions for selecting and uploading a new firmware file.
To update the PC driver: click on the Installer link like a new
installation.
Verify the network is configured correctly
Try to connect to the Flasher-PRO web page. Consult the networking
section above for details.
If that does not work, try:
Turning off any firewall/antivirus software.
f
Picking a different connection method. For example, try the fixed IP
f
addressing mode.
Using recovery mode to make sure the Flasher-PRO is configured
f
correctly. Recovery mode is entered by holding down the front
button during power-on.
If the Flasher-PRO web page works, but applications don't work:
The DLL may not be installed. Install the DLL using the instructions
f
on page 5 of this quick start guide.
The network settings may be incorrect. Specifically, verify that
f
the Flasher-PRO netmask setting is the same as the PC/laptop's
netmask setting.
The application may be looking for the wrong J2534 device. Make
f
sure "Flasher-PRO" is selected.
If applications work, but not the Flasher-PRO web page:
Verify that your web browser is not using a proxy. (Under Tools >>
f
Options >> Local Area Network Settings)
If your PC/Laptop is running firewall software, try turning it off to
f
see if that is the problem.
Flasher-PRO User's Manual | August 2008
Troubleshooting and Support | Flasher-PRO | 11
Robert Bosch LLC