Cisco Catalyst 2960X-48FPD-L Hardware Installation Manual page 35

Switch Installation
Class 1 laser product. Statement 1008
Warning
Warning This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
device. Statement 1019
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
Warning
1040
For connections outside the building where the equipment is installed, the following ports must be connected
Warning
through an approved network termination unit with integral circuit protection: 10/100/1000 Ethernet.
Statement 1044
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected
last. Statement 1046
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: <113°F (45°C). Statement 1047
OL-28309-02
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
Safety Warnings
25