Cisco Catalyst 2960X-48FPD-L Hardware Installation Manual page 100

Completing the Setup Program
On a command switch, the host name is limited to 28 characters; on a member switch the name is limited to
31 characters. Do not use -n, where n is a number, as the last character in a host name for any switch.
Enter host name [Switch]: host_name
Step 3 Enter an enable secret password, and press Return.
The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive, allows
spaces, but ignores leading spaces. The secret password is encrypted, and the enable password is in plain text.
Enter enable secret: secret_password
Step 4 Enter an enable password, and press Return.
Enter enable password: enable_password
Step 5 Enter a virtual terminal (Telnet) password, and press Return.
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores leading
spaces.
Enter virtual terminal password: terminal-password
Step 6 To configure the country code, enter yes and press Return.
Do you want to configure country code? [no]: yes
Step 7 Enter the country code, and press Return.
Enter the country code[US]:US
Step 8 (Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts. You can
also configure SNMP later through the CLI, Device Manager, or the Network Assistant application. To
configure SNMP later, enter no.
Configure SNMP Network Management? [no]: no
Step 9 Enter the interface name (physical interface or VLAN name) of the connection to the management network,
and press Return. For this release, always use vlan1 as that interface.
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Step 10 Configure the interface by entering the switch IP address and subnet mask and pressing Return. The IP address
and subnet masks shown are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
90
Configuring the Switch with the CLI-Based Setup Program
OL-28309-02