Mitsubishi Electric CP-D2E User Manual page 10

Safety regulations
WARNING
Do not disassemble or modify the printer
The printer has both hot and high voltage parts on the inside. Touching these parts may
result in burns, electric shock, and/or damage to the printer. Never attempt to
disassemble or modify the printer as this may lead to electric shock or printer
malfunction.
For service or repair, contact your dealer.
Do not allow liquids near the printer
If liquid gets into the printer, it may result in fire or electric shock.
Do not place heavy objects on the printer
Heavy objects may damage the printer cabinet, resulting in fire or electric shock.
Damage may also result from the printer being dropped or falling.
Do not install the printer in the following places
To prevent fire, electric shock, and printer malfunction, do not install the printer in the
following places:
• Dusty, humid, or oily places
Should any dust or liquid get into the printer, it may result in fire or electric shock.
• Extremely hot places
Do not expose the printer to direct sunlight, such as inside a car or near a window or
extremely high temperatures, such as near a heater. Doing so may damage the printer
cabinet, resulting in fire or electric shock.
Use the printer in an environment with an ambient temperature between 10 to 35°C
(50 to 95°F) and humidity of 30 to 80%.
Do not use the printer in the following places
• Unstable or inclined surfaces.
• Outdoors (particularly on beaches, etc.), or places that expose the printer to excessive
dust or debris.
• Places subject to rain, dripping, or enclosed places where condensation could occur
such as inside a plastic bag.
EN-10