C Onnecting The - Fujitsu ScanPartner 15C User Manual

2 2 . . 7 Connecting the Cable
i). Turning the Power Off
Depress the side marked "O" to turn the power off.
Connect the power cable and SCSI signal cable as shown in Figure 2-8.
ii). Turning the Power On
Depress the side marked "I" to turn the power on. The POWER LED will light up. If
not, please check the power source.
iii). SCSI Termination
The Fujitsu ScanPartner 15C comes complete with a built in SCSI terminator. If the
scanner is the last device in a SCSI chain the terminator should be switched on. If
the scanner is not the last device the terminator should be off. The terminator
on/off switch is located on the back of the scanner, to the left of the SCSI cable
connectors.
Host PC
Term.
Host PC
Term.
scanner
(Terminator Off)
scanner
(Terminator On)
2-9
SCSI Device
Term.