Transition Networks FBRM1xxx-1xx Quick Reference Manual

Hide thumbs Also See for FBRM1xxx-1xx:

Advertisement

Quick Links

FBRM1xxx-1xx & BFFG1xxx-1xx
Media Converter
Quick Reference Guide
33378.C

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FBRM1xxx-1xx and is the answer not in the manual?

Questions and answers

Summary of Contents for Transition Networks FBRM1xxx-1xx

  • Page 1 FBRM1xxx-1xx & BFFG1xxx-1xx Media Converter Quick Reference Guide 33378.C...
  • Page 2: Table Of Contents

    Table of contents SHIPPING BOX CONTENTS ...........................3 USB DRIVER INSTALLATION ..........................3 ............................3 NSTALLING DRIVER ..................3 EFAULT USERNAME PASSWORD CONFIGURATION Default user name and password..........................3 Default IP configuration ............................3 HARDWARE INSTALLATION ..........................3 FBRM/BFFG ......................3 NSTALLING A CHASSIS MODULE OAM setup peer management ..........................3 FBRM/BFFG ....................4 NSTALLING A...
  • Page 3: Shipping Box Contents

    Introduction Default username, password, and IP configuration This quick start guide presents information and instructions about the Default user name and password FBRM/BFFG media converter. The topics are as follows: • Shipping box contents The FBRM/BFFG comes from the factory with the following default usernames and passwords.
  • Page 4: I Nstalling A Fbrm/Bffg Standalone Module

    Press the ENTER key to launch the MMU interface. Installing a FBRM/BFFG standalone module Enter a password (default is private). Click the LOGIN button to launch the main menu. Note: By default, OAM is enabled on the fiber port. Click on the VIEW button to display the cards in the chassis. Install the FBRM/BFFG converter’s provided external power supply to power up the device.
  • Page 5: Upgrading Firmware

    Upgrading firmware OAM configuration The firmware image on the converter can be upgraded by these methods: The OAM can be configured via: • XModem • USB CLI • TFTP protocol • Telnet • OAM • IP based (directly to the FBRM/BFFG converter) When enabled, OAM is done automatically when the active peer detects •...
  • Page 6: Point System Chassis Agent (Mmu) Method Web-Based

    Point System chassis agent (MMU) method web-based To configure OAM via the MMU, do the following: Open a Web browser. At the URL, type the IP address (nnn.nnn.nnn.nnn) of the chassis MMU. Press the ENTER key to launch the MMU interface. Enter a password (default is private).

This manual is also suitable for:

Bffg1xxx-1xxFbrm1xxx-1 seriesBffg1xxx-1 series

Table of Contents