Controlling System4 Video Multiplexers; Accessing The Mux Main Control Menu - Bosch IntuiKey Keyboard User Manual

IntuiKey Keyboard
4

Controlling System4 Video Multiplexers

This section applies to KBD-Universal and KBD-Digital Models.
4.1

Accessing the MUX Main Control Menu

1.
2.
NOTICE! If you are already in a product sub-menu, and multiple products are connected to the
IntuiKey, the keyboard provides a means for easy switching between the devices. Press and
i
hold the PROD key for longer than 1 second to enter the device address selection mode. Enter
the address of the desired device to make the keyboard immediately switch to that device's
main menu.
3.
Display Description
VCR
SEQ
MONA/B Indicates which multiplexer monitor is currently under control. It toggles between
REC
PLAY
ZOOM
ALM xx
NOTICE! While in multiplexer control mode, the product title continuously displays MUX #—
(where the dash represents the multiplexer number). The numeric entry cell is used to enter
i
numeric values needed to control the multiplexer (i.e. camera number, allplex number, shot
number, etc.). Above the numeric entry cell is a title displaying the multiplexer's current mode
(i.e. cameo, camera entry, or menu mode).
4.
Bosch Security System, Inc.
Press PROD to put the keyboard in the Product Selection Mode. The softkey display
shows the Product Selection menu. Depending on the number of devices that are
connected to the IntuiKey, the list may show up to 32 total devices spanning 3 menu
screens.
Press the softkey button adjacent to the desired multiplexer in the display. The softkey
display menu will change to the top level menu associated with the device.
The status display shows the MUX mode display.
Camera
Rec
VCR
12
Play
Seq
Zoom
MONA
MUX#01
ALM 13
Figure 4.1 System4 Mode Status Display
Indicates that the multiplexer is in a VCR test mode (routing the VCR video being
recorded to the monitor).
Indicates that the multiplexer is running a sequence.
MONA and MONB for each press of the MON key.
Indicates that the multiplexer is in an action alarm mode.
Indicates that the multiplexer is in a contact activated alarm mode.
Indicates that the VCR is currently recording.
Indicates that the multiplexer is displaying a videotape replay.
Indicates that the multiplexer is displaying a zoomed image.
Indicates that a device connected to the IntuiKey, with address number xx is in
alarm. The IntuiKey's ALARM button light and the keyboard begins to beep.
The softkey display show the MUX Main Control menu.
Controlling System4 Video Multiplexers | en
User Manual
27
F.01U.080.637 | 1.92 | 2008.12