Using The Coffee Maker For The First Time; Turning The Appliance On; Turning The Appliance Off; Impostare L'autospegnimento (Stand By) - DeLonghi ESAM 04.120 Instructions For Use Manual

pliance.
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10a only.
if the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
professional.

Using the coffee maker for the first time

Please note:
• Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
• You should customise water hardness as soon as possible
following the instructions in the section "Setting water
hardness" on page 15.
1. Plug the appliance into the mains socket .
2. remove the water tank, fill to the MaX line with fresh
water then replace in the appliance (fig. 1).
3. Turn the cappuccino maker outwards and place a contain- Turn the cappuccino maker outwards and place a contain-
er with a minimum capacity of 100 ml underneath (fig.
2).
4. Place the main switch on the back of the appliance in the
I position (fig. 3).
5. The lights ,
6. Turn the steam dial anticlockwise as far as it will go (fig.
5). This is priming the water system. (it is normal for the
machine to make some noise).
7. Wait for delivery of hot water to stop automatically. The
lights ,
dicate that you must close the steam tap by turning the
steam dial to the 0 position.
8. Turn the steam dial to the 0 position. The appliance goes
off automatically.
To use the appliance, turn it on.
Please note :
• When using the appliance for the first time, you need to
make 4-5 cups of coffee or 4-5 cappuccinos before the ap-
pliance starts to give satisfactory results.

TURNING THE APPlIANCE ON

Please note:
Before turning the appliance on, make sure the main switch on
the back of the appliance is in the I position (fig. 3).
each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
, flash.
, alternatively flash to in-
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
during rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath.
avoid contact with splashes of water.
• To turn the appliance on, press the
The and
is heating up and performing an automatic rinse cycle. By
circulating the hot water, the appliance heats both the
boiler and the internal circuits.
When the and
appliance is at temperature.

TURNING THE APPlIANCE OFF

each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
during rinsing, a little hot water flows from the coffee spouts.
avoid contact with splashes of water.
To turn the appliance off, press the
appliance performs a rinse cycle.
Please note:
if the appliance is not used for an extended period, place the
main switch in the 0 position (fig. 6).
Important!
To avoid damaging the appliance, never place the main switch
(fig. 6) in the 0 position while the appliance is on.
IMPOSTARE l'AUTOSPEGNIMENTO (STAND
BY)
The appliance is set by default to go off if not used for two
hours.
The time can be changed so that the appliance switches off
after 15 or 30 minutes, or after 1, 2 or 3 hours.
1. With the appliance in stand-by (the main switch has to be
turned to i position) (fig. 3), Press and hold the eCo button
until the lights at the back of the control panel come on
(see fig. after step 2).
2. Select the required period of time (15 or 30 minutes or 1,
2 or 3 hours) by pressing the
time table).
9
button (fig. 4).
lights flash while the appliance
lights remain on steadily, the
button (fig. 4). The
button (see the light/