DeLonghi ESAM2800.SB Instructions For Use Manual
DeLonghi ESAM2800.SB Instructions For Use Manual

DeLonghi ESAM2800.SB Instructions For Use Manual

Bean to cup espresso and cappuccino machine

Advertisement

5713216831/
02.13

Advertisement

Table of Contents
loading

Summary of Contents for DeLonghi ESAM2800.SB

  • Page 1 5713216831/ 02.13...
  • Page 2 BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instructions for use ESAM 2200/ ESAM2600/ESAM2800...
  • Page 4 A4 A5 B12 B13...
  • Page 7: Table Of Contents

    CONTENTS SETTING WATER HARDNESS ....15 Measuring water hardness ......15 INTRODUCTION ........7 Set water hardness ......... 16 Symbols used in these instructions ....7 SETTING THE TEMPERATURE ....16 Letters in brackets ..........7 Troubleshooting and repairs ......7 TECHNICAL SPECIFICATION ....
  • Page 8: Introduction

    INTRODUCTION SAFETY Thank you for choosing the ESAM2 Bean to cup Fundamental safety warnings coffee maker. Danger! To get the best result of your new coffee machi- This is an electrical appliance and may therefore ne please readthese instructions carefully before cause electric shock.
  • Page 9: Designated Use

    DESIGNATED USE DESCRIPTION This appliance is designed and made to prepare Description of the appliance coffee and heat drinks. (page 3 - All other use is considered improper. A1. Grinding adjustment knob This appliance is not suitable for commercial A2. Main switch use.
  • Page 10: Preliminary Checks

    Using the coffee maker for the first time B12. light: grounds container full B13. light: general alarm Please note: B14. Rinsing or descaling button with light • Coffee has been used to factory test the ap- B15. ECO energy saving mode button with light pliance and it is therefore completely normal for there to be traces of coffee in the mill.
  • Page 11: Turning The Appliance Off

    tion of this cycle. 15min 30min Danger of burns! During rinsing, a little hot water comes out of the coffee spouts and is collected in the drip tray underneath. Avoid contact with splashes of water. 3. Press the ECO button to confirm the selec- tion and return to normal use of the applian- • To turn the appliance on, press the but-...
  • Page 12: Selecting The Quantity Of Coffee In The Cup

    nal circuits of the appliance and thus raising Selecting the quantity of coffee in the cup Select the required quantity of coffee by turning the coffee temperature. the knob. • warm the cups by rinsing them with hot wa- ter (using the hot water function). Making coffee using coffee beans Important! Do not use caramelised or candied coffee beans as they could stick to the coffee mill and make it...
  • Page 13: Making Cappuccino

    damage the appliance. 6. Turn the steam knob to the I position. Ste- • Never use more than one level am is delivered from the cappuccino maker, measure or it could dirty the giving the milk a creamy frothy appearance inside of the machine or block and making it more voluminous;...
  • Page 14: Heating Water

    CLEANING 2. Wait for a few minutes for the cappuccino maker to cool down. Grip the handle of the Cleaning the coffee maker cappuccino maker tube firmly in one hand The following parts of the machine must be cle- and with the other rotate the cappuccino aned regularly: maker anticlockwise (fig.
  • Page 15: Cleaning The Drip Tray

    Cleaning the drip tray Cleaning the pre-ground coffee funnel Check regularly (about once a month ) that the Important! pre-ground coffee funnel (A6) is not blocked. If If the drip tray is not emptied regularly, the water necessary, remove coffee deposits with a brush. could overflow from the edge and seep inside or around the machine.
  • Page 16: Descaling

    red buttons have snapped out. forms a series of rinses and pauses to remo- 8. Close the infuser door. ve limescale deposits from inside the machi- 9. Replace the water tank. After about 30 minutes, the water tank is empty DESCALING and the light comes on.
  • Page 17: Set Water Hardness

    Level 3 The appliance complies with the fol- lowing EC directives: • EC Regulation 1275/2008 for standby; Level 4 • Low Voltage Directive 2006/95/EC and sub- sequent amendments; Set water hardness • EMC Directive 2004/108/EC and subsequent 1. Make sure the appliance is off (but connec- amendments ted to the mains electricity supply and with • Materials and accessories coming into con- the main switch in the I position);...
  • Page 18: Meaning Of Lights During Normal Operation

    MEANING OF LIGHTS DURING NORMAL OPERATION LIGHTS DESCRIPTION MEANING The lights flash The water is not yet at the ideal tempe- rature. Wait for the lights to come on steadily before making coffee The lights are on steadily The appliance is ready to make coffee The light is on steadily The appliance is delivering one cup of coffee...
  • Page 19 LIGHTS DESCRIPTION MEANING WHAT TO DO The light is on ste- The grounds container is Empty the grounds container and drip tray, clean and replace (fig. full or missing adily 23). Important: when removing the drip tray, the grounds container MUST be emptied, even if it contains few grounds.
  • Page 20: Troubleshooting

    TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services. PROBLEM POSSIBLE CAUSE SOLUTION The coffee is not hot • The cups were not preheated. • Warm the cups by rinsing them with hot water (N.B. you can use the hot water function). • The infuser has cooled down because • Before making coffee, heat the infuser by 2/3 minutes have elapsed since the last pressing the...
  • Page 21: Electrical Requirements

    ELECTRICAL REqUIREMENTS Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.

This manual is also suitable for:

Esam2600Esam2800Esam 2200

Table of Contents