Sewing Advisor Display Guide; Selection Buttons - Husqvarna Viking Huskylock 936 User Manual

2. SEWING ADVISOR DISPLAY GUIDE

2-1. Selection buttons

The buttons below can either be pressed one step at a time or held until the desired setting is
obtained.
1. : Auto button
Press for Auto Mode. Standard settings are displayed.
2. : Memory button
Press to retrieve stored settings or store new setting preference in memory.
3. : Stitch selection button
Retrieve the 16 pre-set stitches in Auto Mode.
4. : Fabric selection button
Select fabric type in Auto Mode.
5. : Cursor button
Access Manual Mode to enter and or alter settings.
Cursor moves as follows:
Stitch length - Differential feed ratio - Cutting width(if applicable) - Thread tension
6.-7. : Plus(+) and Minus(-) button
In Manual Mode, settings increase(+) or decrease(-).
In Memory Mode, cursor moves to stored memories.
8. : Speed selection button
Select maximum speed mode. Refer to "1-4. Sewing speed (page 5)".
9. Sewing Advisor display
All stitch settings can be shown in the display.
—9—