Set-Up - Sharp AL-1633 Operation Manual

SET-UP

1
Remove all pieces of tape, then open
the SPF or the document cover and
remove the protective material.
2
Use a coin (or other suitable object) to
remove the screw.
Store the screw in the paper tray as described
Note
in step 6 because it must be used if the
machine has to be moved. (p.69)
3
Install the TD cartridge.
For installation of the TD cartridge, see the next
page.
4
Gently lift and pull out the paper tray
until it stops.
5
Remove the pressure plate lock.
Rotate the pressure plate lock in the
direction of the arrow to remove it
while pressing down the pressure
plate of the paper tray.
6
Store the pressure plate lock which
has been removed in step 5 and the
screw which has been removed in
step 2 in the front of the paper tray.
Pressure
plate lock
Screw
7
Ensure that the power switch of the
machine is in the OFF position. Plug
the power cord into the nearest outlet.
• If you use the machine in a country other
than the country where the machine was
Caution
purchased, you will need to make sure that
your local power supply is compatible with
your model. If you plug the machine into an
incompatible power supply, severe damage
to the machine will result.
• Only insert the power cord into a properly
grounded wall socket. Do not use extension
cords or power strips.
Connect the machine to a power outlet which
Note
is not used for other electric appliances. If a
lighting fixture is connected to the same
outlet, the light may flicker.
To store the pressure
plate lock, rotate the lock
to fix it on the relevant
location.
For two-tray model,
follow steps 4 to 6 for
both the upper and lower
trays except for storage
of the screw.
13
1