Simple Button Operations For Changing Channels; Using Flashback (A) On The Remote Control Unit - Sharp PZ-MR2X Operation Manual

Watching TV
Plasma Display TV
MAIN POWER
POWER INPUT
Channel display
( Displays after 3 secs. )
CH
VOL
CH /
SAT.1
12
PAL
B/G
SAT.1
12
MONO
Simple button operations for changing
channels
Using CHa a a a a /b b b b b on the remote control unit
• Press CHa a a a a to increase channel number.
• Press CHb b b b b to decrease channel number.
A
• CHs/r on the Plasma Display operates the same as
CHb b b b b /a a a a a on the remote control unit.
Using FLASHBACK (A) on the remote
control unit
Press A to switch the currently tuned channel to the
previously tuned channel.
Press A again to switch back to the currently tuned
channel.
Using 0 – 9 on the remote control unit
Select the channels directly by pressing buttons 0 to
9.
a
To select a 1-digit channel (e.g. channel 2):
• Press 2. If is indicated and the picture does not
"2"
change, press o to switch over to the 1-digit select
mode and press 2 again.
To select a 2-digit channel (e.g. channel 12):
• Press o to set the 2-digit select mode. Press 1,
followed by 2.
A
• Complete this procedure within 3 seconds, otherwise the
selection will not be made on the 2-digit channel mode.
When viewing Teletext information
View a page directly which is 3-digit page number from
100 to 899 by pressing buttons 0 to 9. With Teletext,
you do not use o. See page 63.
E-20