Table of Contents
Advertisement
Watching TV
Channel display
Plasma Display TV (Panel Unit)
INPUT
A
MENU
Channel display
( Displays after 3 secs. )
SAT.1
1
PAL
B/G
CH
CH /
0–9
/
SAT.1
12
PAL
B/G
SAT.1
12
MONO
When preset download finishes, your initial auto
installation is completed.
• "Auto Installation completed." displays. After that, the
screen changes to the auto installation menu.
7.
Watching TV
The setup menu disappears and you can watch the
programmes on channel 1.
Simple button operations for changing
channels
Using CHa a a a a /b b b b b on the remote control unit
• Press CHa a a a a to increase channel number.
• Press CHb b b b b to decrease channel number.
A
• CHs/r on the Plasma Display TV (Panel Unit) operates
the same as CHb b b b b /a a a a a on the remote control unit.
Using FLASH BACK (A) on the
remote control unit
Press A to switch the currently tuned channel to the
previously tuned channel.
Press A again to switch back to the currently tuned
channel.
Using 0 – 9 on the remote control unit
Select the channels directly by pressing buttons 0 to
9.
a
To select a 1-digit channel (e.g. channel 2):
• Press 2. If
is indicated and the picture does not
"2"
change, press o to switch over to the 1-digit select
mode and press 2 again.
To select a 2-digit channel (e.g. channel 12):
• Press o to set the 2-digit select mode. Press 1,
followed by 2.
A
• Complete this procedure within 3 seconds, otherwise the
selection will not be made on the 2-digit channel mode.
When viewing Teletext information
View a page directly which is 3-digit page number from
100 to 899 by pressing buttons 0 to 9. With Teletext,
you do not use o. See page 61.
21
Advertisement
Table of Contents
