Connecting The System - Sharp PZ-MR2X Operation Manual

Preparation

Connecting the system

1.
Connecting the system cable, the power cord and the speaker cables to the Plasma Display
(bottom view)
(WHITE)
A
• Two speaker cables of different lengths are supplied. As
shown in the diagram, connect the longer speaker cable
to the left speaker and the shorter to the right.
2.
Connecting the system cable and the power cord to the AVC System
L
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
POWER CORD CONNECTED.
E-11
Plasma Display (rear view)
Speaker cable
(GRAY)
System cable
Speaker cables
(GRAYeGRAY with white stripe)
AVC System (rear view)
INPUT 3
ANT
OUT ANT/CABLE 75Ω MONITOR OUTPUT S-VIDEO
Speaker cable
Power cord
Red
Black
(GRAY)
COMPONENT COMPONENT
Y P P Y P P
B R B R
INPUT 1
INPUT 2
VIDEO R-AUDIO-L S-VIDEO VIDEO R-AUDIO-L
Black
Red
As you apply pressure to this part,
insert the speaker cable. It is
important to match polarity when
connecting the speaker cables to the
terminals.
Insert the speaker cable
Lift up the snap clip.
Insert the wire into
the hole of the
connector.
Lower the snap clip
to grip the wire in
place.
System cable
(WHITE)
RS-232C DISPLAY OUTPUT-1
DISPLAY OUTPUT-2
AC INPUT
110V - 24OV
Power cord