Installation & Cable Management - Havis DS-PAN-110 Series Owner's Manual

Installation & Cable Management
1). Install the Mounting Bracket to the Motion Device using (3) 1/4"-20
screws (Hardware Kit Item 3). Torque screws to 13.4Nm (120 in-lbs) ± 10%.
NOTE: Numerous hole patterns present in Mounting Bracket should accommodate
most competitor's motion devices.
1/4"-20 Screws
Mounting Bracket
Typical Motion Device Example
(not included)
2). Orient the Docking Station in a position that is comfortable to work with.
3). Install all cables that are necessary for computing needs.
NOTE: If mounting Power Supply to Docking Station, go to Page 10 before completing Step 3
4). Use Zip Ties (Hardware Kit Item 4) to strain relieve cables to the Strain Relief
Loops at front of Docking Station.
NOTE:
Holes shown will
accept Zip Tie/Push Pins
(Hardware Kit Item 1)
for strain relieving
Antenna cables.
4