Using Your 3 In 1 Coffee Center - Preparing Coffee - West Bend L5563G Instruction Manual

This appliance may be equipped with an Auto Shut-Off feature. When equipped with
Auto Shut-Off, the espresso boiler and corresponding indicator will turn off after 10
minutes of continuous use. The Keep Warm feature and corresponding indicator will
turn off after 2 hours of continuous use. To "re-start" either the espresso or
coffeemaker, switch the corresponding power switch to the "OFF" position and then
switch back "ON". Always switch each power switch to the "OFF" position when
finished using the appliance.
U Y
SING OUR
1. Place appliance on dry, level, heat-resistant surface away from any edge.
2. With both switches in the "OFF" position, plug cord into a 120 volt AC electric
outlet only.
3. Swivel out the brew basket and place a #4 paper coffee filter into the brew
basket. Add desired amount of coffee into the filter. We recommend one
measure (measuring spoon provided) of ground coffee for each cup of brewed
coffee to start. After using your coffeemaker a few times, adjust the amount of
coffee to suit your own taste. Note: The coffee grind should be appropriate for a
"drip" coffeemaker. Do not use coffee that is ground to a powder like
consistency as this will prevent water from passing through the coffee and may
cause hot water or hot to coffee overflow.
4. Close the brew basket by pushing in firmly until the basket touches the side of
the coffee machine and the basket "clicks" into place. If the brew basket is not
closed properly, hot water or hot coffee may overflow. Note: Make sure the filter
is seated properly in the basket and does not fold over itself when closing the
brew basket as this may cause hot water or hot coffee to overflow or it may
allow the water to bypass the coffee grounds, producing a very weak coffee
brew.
5. Open the hinged water reservoir and pour in the desired quantity of clean cool
water for the number of cups you are brewing. Never pour more water into the
reservoir than the marked maximum level. For maximum flavor, do not use
warm or hot water to fill reservoir.
6. Place the coffee carafe with lid in position on the warming plate. Make sure that
the coffee carafe sits flat on the inside circle of the warming plate. Note: The lid
of the carafe must be properly positioned on the coffee carafe. If the covered
carafe is not in place during the brew process hot water or hotcoffee may
overflow.
7. Turn the appliance "ON" by using the CAFFÉ on/off switch. The indicator light
will illuminate indicating that the brewing process has begun. Note: As long as
the red indicator light is illuminated, the coffee will be kept warm. If the coffee
carafe is removed before the end of the brew cycle, it must be returned properly
to the warming plate so the coffee may continue to brew and to avoid hot water
or hot coffee to overflow.
8. Unplug cord from electrical outlet after use and allow the appliance to cool
completely before cleaning.
•
Using the Pause 'n Serve Feature: The Pause 'n Serve feature allows you to
pour a cup of coffee while it is still brewing. For optimum flavor, allow half of the
quantity of coffee to finish brewing before removing the carafe. Return the
carafe within 30 seconds so the coffee may continue to brew to avoid hot water
or hot coffee to overflow. To prevent scald injury, do not remove any part of
the appliance, other than the carafe, during the brew cycle.
O A
PTIONAL UTO
3 1 C
IN OFFEE
S -O F
HUT FF EATURE
C – P
ENTER REPARING
6
C
OFFEE