Advertisement
To prevent dirt from entering inside of the wheel,
apply Lawn-Boy "A" grease in the groove of the
wheel cover. Fig. 30.
The transmission assembly is filled with
"A"
grease at the factory and should not require addi-
tional lubrication. However, if seepage of the lubri-
cant is noted coming from
around the seals or from
the transmission housing gasket area (Fig. 32-A),
grease can be added through the
zerk fitting
located on, the lower side
of the transmission. Fig.
32-6.
Fig. 30
Every 50 hours of operation the rear wheel bolts
should be lubricated. Remove and clean the wheel
bolt, liberally oil the bearing and each felt washer
and reassemble. Fig. 31.
Fig. 32-A
Fig.
32-6
Should it be necessary to add lubricant to transmis-
sion, watch for an upward movement of the clutch
arm when putting grease in. When movement
is
noted, stop the flow of lubricant immediately.
Fig. 33.
NOTE:
Do not put an excessive amount in transmission
because there is a possibility of a pressure build-
up resulting in seal failures.
Fig. 33
20-8
...................................................................................................................................................................
SERVICE BULLETIN REFERENCES
OCTOBER 1984
Advertisement
