Advertisement
Align the transmission with the mounting hole in
the mower housing. Insert the shoulder bolt
through the mounting hole, install the washer over
the threads, and assemble to the transmission.
Fig. 74.
Secure with the nut tightened to
35-45 in. Ibs.
Fig. 74
Assemble the right
bracket assembly
onto the
shaft. Install three bolts and start the nuts. Tighten
to 142-170 in. Ibs. (12-15 ft. Ibs.)
Fig. 75
SERVICE BULLETIN REFERENCES
OCTOBER
Before installing the wheel cover on the shaft,
apply Lawn-Boy type "A" grease in the groove. This
grease stops dirt and debris from entering
the gear
area of the wheel. Fig. 76.
Fig. 76
Assemble the washer, the retaining ring and the
spacer onto the shaft. Fig. 77.
Fig. 77
Apply Lawn-Boy type "A" grease to the keyseats
in the shaft.
Place the small ratchet spring in hole of the shaft.
Fig.
78
Fig. 78
..........................................................................................................
20.19
iR 1984
Advertisement
