Advertisement
Check to be sure the larger spacer washer is in the
recess of the worm wheel. Push both bearings up
against each end of
transmission assembly.
Assemble the shift fork in the groove of the collar.
As you place the assembly in the gearcase, guide
the lower end of shift fork into pivot hole. Fig. 66.
Fig. 66
Assemble the worm into the gearcase, Turn a few
revolutions to check its freedom. Fig. 67.
Fig. 67
NOTE:
Only Lawn-Boy type "A" grease is approved for use
in this transmission assembly. If another lubricant
is used, it will result in a failure of the transmission.
Fill the lower gearcase with Lawn-Boy type "A"
grea'se until it is level with gasket surface. Fig. 68.
Fig. 68
Assemble a new gasket and set cover in place.
Fig. 69.
NOTE:
There are two assembly dowels molded into lower
case which locate in holes of upper case.
Fig. 69
SERVICE BULLETIN REFERENCES
..........................
20-17
OCTOBER 1984
Advertisement
