Handling And Care - Engl SOVEREIGN 100 Operating Manual

The ENGL SOVEREIGN 100 is on the cutting edge of modern guitar technology, it
boasts a number of efficient features and operating modes: three channels, Clean, Crunch and
Lead equipped with three Gain controls and a several Sound pushbuttons. Clean channel
settings are variable from crystal-clear clean rhythm tone to loud high-gain tone ideal for clean
soloing. The other main channel delivers an abundance of crunch tones through to blistering
hi-gain Lead tones. Individual Volume controls for each channel and two separate voicing
sections access a vast arsenal of tones. The Crunch/Lead channel is also equipped with a
Presence Ratio control and a Depth Boost pushbutton: This combination delivers practical
poweramp treble and bass tuning options (in relation to the clean channel). Two different
crunch and lead distortion modes enhance this combo´s tonal spectrum at the touch of a
pushbutton: Rough for loads of upper-end grit and powerful bottom-end; Smooth for creamy
mids with plenty of punch. Yet another handy tool is the Master Volume featuring volume
switching; two different predetermined volume levels accessible via footswitch for that added
punch during soloing! This feature also enables you to boost the Clean channel for crisp clean
leads.
This amp also features a number of signal paths: a passive, parallel/serial (!) FX loop, a variable
balanced line out featuring speaker simulation and an overload LED. The integrated ECS
(Emergency Circuit System) protects the amp from damage due to power tube defects/failure
and ensures the amp continues to function at reduced power until the failed tube can be
replaced.
Superior craftsmanship and finishing and quality components are what this device is all about.
However keep in mind, that a few precautions will radically extend tube life (see handling and
care guidness).
PLEASE NOTE:
Read the Operator's Manual carefully and thoroughly, especially the following Handling
and Care section as well as the framed guidelines. Avoid operating errors and potential
damage to the amp by heeding the guidelines and cautionary remarks in this manual. The
footnotes also cover a few convenient pointers and interesting tips on several functions.
These are listed at page 8 and 9 of the manual. This manual covers all the features, operational
guidelines, technical specifications and many helpful hints and tips. It should answer all your
questions, so keep it in a safe place and refer to it when necessary.

Handling and Care

Protect the amp from mechanical knocks (tubes!).
Let the amp cool down before you transport it (app.10 minutes).
Tubes need about 20 seconds to warm up after you switch the power on,
and furtheron a few minutes before they reach their full power capability.
Avoid storing the amp in damp or dusty rooms, they are hard on jacks,
switches and potentiometers.
Make sure air can circulate at the front and top of the amp
to allow for adequate cooling (increases component life).
Never operate the amp without an adequate load.
Replace tubes with select ENGL replacement tubes (special selection criteria) to avoid
microfonic properties, undesireable noise and unbalanced performance.
3