GE PD900 Installation Instructions Manual page 11

Standard Installation Instructions
D
Attach the Lower Trim
D5
Attach the lower trim (supplied separately
with the range) to the bottom of the
vertical side trim with the 4 screws
supplied.
Side trim
Lower
trim
Locating the Stop Screw
D6
It is suggested that two people lift the
range and carefully slide it towards the
back of the opening. When the range
is approximately 1" from the back of
the opening, lift the front of the range
approximatley 1/2" to clear the stop screw
located in the sides of the cabinet. Slide
the range until the range is seated into the
opening.
Lower the front of the range onto the
countertop.
Installation Instructions
Attach 2
screws
each side
Check For Proper Installation of
D7
the Stop Screw
Look at both sides of the range under the
door. The stop screws must be located in
the notch on the sides of the range, and
not touch the top of the notch when the
range is fully seated on the countertop. If
the screws do not meet the requirements,
move the screws to a position that meets
these requirements.
(See illustration below.)
Lower
right end
of front
Lower
frame
trim
11
cont.
Clear
Notch in bottom
Shoulder screw
of side trim
(Continued on following page)